dipping coming off limb cup...
ok i have a problem.... i have had my z28 about 2 weeks... one of my limb cups is flaking off paint.... the rest of the bow is fine... it seems like the limb cup part was not properly cleaned before dipping.. will they cover this? i know it says the finish is not covered in the warranty.. but its new and i have only had it two weeks... i will post a pic in a sec...
working on the pics.... the batts were dead... charging..
Last edited by ctious; 08-29-2008 at 09:17 PM.
and for the record.. every time i adjusted the weight i loosened the bolts...
any word?????? I know everyone was gone for the weekend...
it also says to check and make sure all of the screws were tight on that red paper you got too.. i believe after 75 shots. i could be wrong though. its a camo bow it blends in.
GTO
Envy #288
If your turning the bow up and down you will get that. its a film dip and tightening or losing the lock down bolts will pull on the coating. kind of what it looks like anyway.
I had the same on a synergy with the anodizing shining. I now back the bolts way out until I see threads before I turn the limb bolts.
No ifs and or buts Just maybee.
Originally Posted by Maybee-R
oh i backed the bolts out a few turns before adjusting... its only happening on the lower cup.. the top one is fine... i can take my nail to the finish and it will fall off.... i think its just a problem with that one cup..
Then I would give them "Elite" a call. You never know there awesome.
No ifs and or buts Just maybee.
Posting Permissions
Reply With Quote
