Matt,
I installed the rod on my Answer but have a question.
The cable slide is about 3/16" away from the bend in the rod. I hesitate to bring the rod out any further for fear of loosing
the set screw's bite on the rod.
This position has the cable rubbing the string stop at full draw. I can sand the side of the stop for more clearance, or can
I leave it as is? Will it affect the cable motion forward?
2012 ANSWER AT/AP W/ SPEED MODS
2011 PULSE AP
TUNER OF BOWS BY LONG DISTANCE
Member of the JURY MEMBER OF THE LEFTY BROTHERHOOD
"If it ain't broke , I can MAKE it better".
Integrity is doing the right thing when no one is looking.
as long as you have vane clearance 3/16 is fine you should be able to move it back though an 1/8 inch isnt much and you would not be as deep in the angel at full draw i found with some bows it will touch the rubber stop but dose not affect anything, its more important to remove torque than anything.Originally Posted by archer58inPA
DEALER FOR
ELITE,MATHEWS,MISSION
STROTHER,PSE,DARTON,BEAR
Vane clearance is OK. I'll shoot it tomorrow.
thanks for the assist.
2012 ANSWER AT/AP W/ SPEED MODS
2011 PULSE AP
TUNER OF BOWS BY LONG DISTANCE
Member of the JURY MEMBER OF THE LEFTY BROTHERHOOD
"If it ain't broke , I can MAKE it better".
Integrity is doing the right thing when no one is looking.
no problem
DEALER FOR
ELITE,MATHEWS,MISSION
STROTHER,PSE,DARTON,BEAR
I will say though at brace it's very tight with Blazer and feathers.
Sent from my Desire HD using Tapatalk 2
glade to hear it took alot of torque out of the bow and you were hitting 4.5" to the right after installation.
DEALER FOR
ELITE,MATHEWS,MISSION
STROTHER,PSE,DARTON,BEAR
Posting Permissions
Reply With Quote