Envy ATA

[Stoney]

My ATA is currently 33 1/4, how do I get it to 33 1/2?

[Z-Rider]

Little more info needed. What number Envy do you have as there was a running change in riser length/limb pocket angles and that will effect ATA measurement.


Sent from my iPhone using Tapatalk

[Stoney]

Little more info needed. What number Envy do you have as there was a running change in riser length/limb pocket angles and that will effect ATA measurement.


Sent from my iPhone using Tapatalk

0238, it was dead nuts until I tore it apart for the Ninja conversion!!

[Z-Rider]

I believe that is after the change. Who has these numbers handy?


Sent from my iPhone using Tapatalk

[Stoney]

I believe that is after the change. Who has these numbers handy?


Sent from my iPhone using Tapatalk

I'm guessing Bfoot, but I haven't been seeing him on here much lately!

[bfoot]

Did you spec the string and cables under tension?

[Stoney]

Did you spec the string and cables under tension?

You're speakin chinese man, you're speakin chinese............I'm a newby!!! No, I didn't, how would a novice go about doing that?


p.s.

Glad you came out of hiding, you working on some secret squirrel frankenbow?

[bfoot]

You're speakin chinese man, you're speakin chinese............I'm a newby!!! No, I didn't, how would a novice go about doing that?


p.s.

Glad you came out of hiding, you working on some secret squirrel frankenbow?

Sorry so long to respond but have not checked older posts lately. What that means is you either put the string on a draw board with a digital scale, crank it up to 100lbs then measure it exactly using a long metal ruler like you use with dry wall. Measure from where the outside of the loop touches the S hook or post to the other end where it touches the post. So you are measuring from end of loop to end of loop minus the diameter of the loop material.
If you do not have a draw board, put a 1/4" wood bolt into the top of your garage door, and on the other end 100lbs of weights (90lbs will work if you have two 45lb plates). So you wrap an nylon belt through the weights and attach to one end of S hook and sting to other, then lift that bad boy and attach the other end to the wood bolt. Suggest you build a draw board makes it a lot easier. So, you do this for string and cables and if you measure very very precisely, you will be close if not dead on for ata, brace, and correct starting position of your cams.

And yes, working on frankenbows, today alone put Prime Centroid cams on Allegiance, E500 and GTO. Not much speed but loving the draw cycle. Send me a pm anytime I can help.