Does the Z have low Berger holes?

[duxbux]

ImageUploadedByTapatalk1335378601.954360.jpgImageUploadedByTapatalk1335378632.231463.jpg
Does this Z have low bergers?

[Rgarbarino]

Looks like it to me based on how the hole looks like it's drilled where the shelf starts to curve. Is this one of the ebay bows? If it's not an ebay bow and does have a full Elite warranty they will replace the riser. They did for me when I found out my 2009 Z had low holes.

[duxbux]

It has a full warranty. I checked the # with Elite. No G5 here.

[cbc]

Looks low, berger holes look too far below Elite medallion, Elite replaced my riser also

[pbuck]

I thought it was only a few 2009's that had the low holes? Is this a different bow than your sig line suggests?

[thumper]

I might be wrong but I think pbuck has it right. I thought it was on some early model z's . Probably done on a Monday .

[hartofthethumb]

If Elite is replacing the risers with low holes, I wonder if they are destroying them... If so, that's a shame. I know there are issues with a few rests, but with most you can just set the arrow at 7/8" center height and shoot 'em just fine.

[Sean]

If Elite is replacing the risers with low holes, I wonder if they are destroying them... If so, that's a shame. I know there are issues with a few rests, but with most you can just set the arrow at 7/8" center height and shoot 'em just fine.

Recycling is the wave of the future Ben. Have you priced scrap lately?

I do agree, lots of good bows being destroyed if they are in fact throwing them into the scrap tub.

[pbuck]

Just looked at my Z and there's only 1/16 - 1/8" between the medallion and the hole. Your bow has more than that.

[1fowlhunter]

My 09 Z28 has low Berger holes and shoots fine. I was told that you can't skimp on the sight though, my AAE Pro Drop doesn't have any issues.