ticking sound in bottom cam ????

[BHUNTN]

My Pulse just started ticking when it is almost to full draw. Kind of sounds like something that is getting pulled to tight and is about to break. Mod screws are all tight. Took the mod off cleaned it up, even put some wax on the edges to tighten things up. This stopped it for a bit but now it is doing it again... What in the heck is up????

[bponb]

check your draw stops. Some of the earlier production stops are cracking.

[mchildress]

Did you wax the threads on the mod screws? That usually stops any noise from them.

[BHUNTN]

I put lock tite on the mod screws..the draw stops are the new ones plus the sound starts about an inch before you reach the stops..

[3Fletch]

You may want to pull your draw module off and wax the parts of the mod that contact the cam. Put it back together and you will be good. The Mods have parts that recess into the cam which lock the two together. If there is any movement at all then a clicking noise can be heard. Be careful with the mod screws, unfortunately they are not long enough to grab all of the threads in the mod and can easily be stripped out, so do not over tighten... You can get tapered head Allen screws that are long enough to grab all the threads. I have done this for a friends bow and they will allow you to tighten up enough to eliminate the clicking sounds...