Pure spec question

[Skye5317]

I just built a set of strings for my pure. After 2 days of sitting I remeasured the lengths of the strings at 100# and 1/4" posts and all strings were exact lengths called for. I put them on and now my ata is a little over 1/4" short and poundge is up a good bit. I remeasured the old strings, which were almost new, and all were about 1/4" long.
My question is should I be worried about the short ata or shoot it as is if draw length comes out right? The extra poundage does not bother me but I am worried about what it may do to the limbs.
Any help would be appreciated.
Thanks,
Duke

[Maybee-R]

I just built a set of strings for my pure. After 2 days of sitting I remeasured the lengths of the strings at 100# and 1/4" posts and all strings were exact lengths called for. I put them on and now my ata is a little over 1/4" short and poundge is up a good bit. I remeasured the old strings, which were almost new, and all were about 1/4" long.
My question is should I be worried about the short ata or shoot it as is if draw length comes out right? The extra poundage does not bother me but I am worried about what it may do to the limbs.
Any help would be appreciated.
Thanks,
Duke

ATA specs are +or- 1/4. I wouldnt worry much as long as the weight isnt crazy high. 3 pounds or so. any more I would probably lower the weight.
JMO! to short on the harness will get higher let off also 1/4 seems like a lot to me though.