Elite Limbs
I have a question. I was under the impression that limbs were "finished" by machine. Does anyone know if this is true?
The reason I ask is that on my new Pulse I noticed the distance from the end of the limb to the stops on the cams is quite a bit different from one limb to the other. In other words, if I measure the distance from the axle holes to limb ends I get a different measurement from limb to limb.
The bow shoots great. Smooth and accurate. Just wondering!!
2011 Pulse (Max1) 54# @ 27"
2010 Judge (Snow) 49# @ 26" (now my daughters)
This means I no longer have a back up!
interesting....
2011 Pure Sno AT 29/60
Frequent Frankenbower
Sounds to me like something you should PM JKK or HunterPete about.
This is something that Elite should know about to address.
2012Answer in hand!!!
2011 Elite AP Hunter
2010 Elite AP Judge & Elite AP Snow Z-28
When my bow shop called Elite they claimed it is not an issue. I'm just checking...and wondering. Maybe I will PM HunterPete. Good idea!
2011 Pulse (Max1) 54# @ 27"
2010 Judge (Snow) 49# @ 26" (now my daughters)
This means I no longer have a back up!
I'm guessing that the MOST important measurement is between the limb pocket pivot and axle... have you measured that?
Just curious.
Originally Posted by eltaco
Yes...all other measurements are fine. And like I said the bow is shooting great.
2011 Pulse (Max1) 54# @ 27"
2010 Judge (Snow) 49# @ 26" (now my daughters)
This means I no longer have a back up!
I wouldn't sweat it at all.
Enjoy that bow... I hear it's a sweeeet shooter
Posting Permissions
Reply With Quote