Modified my Toad Press today.

[tomkat04]

I modified my Toad Press today until I get my new press made. I wanted to get the draw board built into the press.

Here is what I got. I have to get the safety attached yet, that's why I used my wife's bow for the initial test run

It takes up a lot less room and works great! I can put it upside down to check the timing dots as well.

[Deer3083]

Looks great bud.

[tomkat04]

Thanks. It works great too. When I get close with the winch, I can use the press to final adjust to get the stops exactly where I need them.

[eros]

Nice job. Good idea on the choice of the test bow.

[eweese18]

Get a clip on that string man, hate to see the loop blow and the bow dry fired.

[TEXAS 10PT]

Get a clip on that string man, hate to see the loop blow and the bow dry fired.

I was thinking the same thing. Don't trust your D-loop without an arrow. Just want to protect your bow bro!!! Your shop is looking good. If I ever get off my keester, I need to get my bow shop set up. I've got everything just need to clear out some space.

TEXAS

[Rgarbarino]

Always use a safety clip. Even on the draw board I'll have an arrow nocked and sitting right in front of it is a morrell yellow jacket so I don't accidentally launch an arrow through the wall into my dining room!

[tomkat04]

I agree with the clip. That's what the original post stated. I have it, just don't have it hooked up yet. That's why I stated I used my wife's bow first.

[PaBowhunter1966]

Thats a Toad Press What year did you get it I have had one for about 5 years I guess but mine is different then yours Looks good though what you did with it.

[tomkat04]

Thats a Toad Press What year did you get it I have had one for about 5 years I guess but mine is different then yours Looks good though what you did with it.

It's the newest version one. 1 year or so old. One of the last one's he built before he couldn't build any more.