Type: Posts; User: jhunter13
Agreed. I praise them every chance I get.
I have always had a ripcord on my answer and never had an issue timing it. Once I removed it it just was different. The cable was pulled just enough so that everything lined up. Thanks again for all...
Called elite...extension on its way. Thanks everyone.
I was re timing my answer after removing a drop away rest that attached to cable and my draw stops, which are all the way out, hit the limbs at the same time, but my timing marks are not lined up on...
Where did you get it?
Looks like 1 1/2" when on bow.
Yeah, I have seen this but cannot find it anywhere.
I just bought a HHA 5019 site with the dial and my one piece riser mount elite quiver doesn't fit any more. Anyone know if they have an extension for this?
Yes. It is pulling 71.5 to 72.
Thanks. This really helps. I am 3/8ths long.
Anyone know where to set draw stops when you are checking draw length? I am checking setup on my Answer and just want to make sure I am checking the right thing.
So.....I tried a 125 gr tip no improvement. Couldn't understand what going on so I started looking at every thing for loose hardware, contact, something had to be off......well I found it. The...
Ripcord. I removed the fletchings and paper tuned the bare shaft. Still nock right tear
100 gr tip. 28 7/8 arrow length
I am really stuck on this one so any help would be greatly appreciated.
2012 Answer, 30 DL, 70 DW.
I was shooting Victory Vforce V3 arrows and bow was shooting perfect bullet holes. Went to...
I was able to get DW, ata, bh in spec. The let off was a little less. Still gonna rotate the cams a little and see if there is a sweet spot.
Gonna rotate them a bit and see. Picked up 15-20 at first but poundage was high.
The draw cycle with the speed mods cannot be compared to the smooth. It is still a nice draw, but completely...
Well after a lot of twisting the speed mods are installed. Here are the new numbers (still using brass nocks)
Victory Vforce V3: 319 fps
Blue Streak: 329 fps
Max Hunter: 337 fps
Victory Vforce V3: 305 fps
Blue Streak: 315 fps
Max Hunter: 323 fps
I cut off the cat whiskers and gained 2-3 fps on each
Victory Vforce V3: 308 fps
Blue Streak: 318 fps
Max Hunter: 325...
Ok finally got everything tuned up on the draw board and ready to start flinging arrows in the chrony.
Sorry. Just started last night. I am running bow on draw board to make sure draw force curve is right so I start with the bow perfectly tuned.
BTW smoot mods are installed. Once I run the gambit with them I will install the Speed mods.
I will be using three different arrows. A Victory vforce v3, CX Blue Streak 350 and a CX Maxima Hunter 250 - yes I know is the incorrect spine, but is dead on at 350 grains.
Ok.....so now that the hunting season is over I am going to go over my Answer and document everything I do including chrono results.
Setup: 70# 30" DL Elite Answer.
On String: D-Loop,Duece 38...