Heith
Respected Member
Ten Point

get the mods yet?

I'm not even sure where I been...I wake up in a different ditch every day

Heath I charge $65 for tuned and shipping back to you. $140 for tune strings and shipping. 509-966-2710 if you have any questions.

Heath, Yes the set screws are on the cam itself, this is what I found

Position Length Draw Stop Setting Speed Rating
slot#- DL--draw stop setting--IBO fps
3 -- 29” -- 4.9 ---- 312 - 322
4 -- 28.5” -- 5.4 -- 306 - 316
5 -- 28” -- 5.8 ---- 300 – 310
6 -- 27.5” -- 6.6 -- 295 – 305
7 -- 27” -- 7.5 ---- 290 – 300
link to Bow spec sheet
http://www.elitearchery.com/technolo...ergy_Specs.pdf


Thanks,Paul aka whitetailfanatic

Hi Heith,
The Cuda cam is that way. You don't get much valley & let-off. For spots, I don't want a lot of creep. I like a smooth draw right into the solid wall. I want to feel the shot, so no creep here. Again, this is what I like for spot shooting.

You can tweak the let-off by adjusting the draw-stops as far out as you can. After that you can mess with the strings/cable twists...but this would be really extreme!!

-- Sme.