eforce draw stops

[eforcer]

question, when adjusting timing on the k8 synergy cam, twisting cable moves it further from draw stop at full draw or brings it closer to draw stop? so if bottom cable is touching stop and top isnt how do i get bottom away from cable stop?

[Elite_Kevin]

If I understand your question. The anti lockup ear on your mods is contacting the cable at full draw, they are not suppose to touch the cable, they are there to keep the bow from locking up if you forget to set the DRAW STOP.:eek:

Move the draw stop toward the wing of the cam, or toward the next larger number, make slight adjustments until the mods ears don't contact the cable.

[eforcer]

they are both almost touching but not touching, i have 75 letoff now, how do i get 80 letoff?

[Elite_Kevin]

Your cams are out of synchronization, put one twist in the power cable on the bottom cam, (this is the take up cable) and recheck the rollover of the cams, once the cams are in synchronization your let-off will go to 80%.

If the bottom cam is still ahead keep putting 1/2 -1 twist in the bottom cable until you have the same gap top and bottom between the mod ear and the cable.