View Full Version : Speed Buttons
02-06-2008, 05:49 PM
What are you guys using to hold the speed buttons in place? In some of the pics I have seen it looks like some type of shrink tubing over them? Could someone tell me how this works?
Thanks for any help.
02-06-2008, 08:43 PM
your factory strings should have them on already mine did its an 07 synergy your right though it is shrink tube
02-06-2008, 11:22 PM
On the earlier 07 synergies they had rubber buttons on the later ones they had brass nocks covered with shrink tubing
02-07-2008, 06:29 AM
The originals did have them. I replaced the string and what wondering how to hold the new ones in place
Where can you get shrink tubing??
02-07-2008, 07:01 AM
You can pick it up at most hardware stores in the electrical dept. Comes in different sizes and you cut to the lengh you need.
02-10-2008, 08:40 PM
You should use brass nocks and than cover them with shrink tubing.. Be careful when heating the tubing to shrink it that u do not burn the string or serving.. NJBuckBuster..
02-10-2008, 08:48 PM
PM me your name and address and I will send you a couple of 6" pieces. You will need 1/4" ID if you choose to buy some yourself. Use a hair dryer to shrink it and you won't have to worry about burning your strings.
Powered by vBulletin® Version 4.1.10 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.