View Full Version : Aigil spacer question
10-27-2009, 11:10 AM
I changed the limbs out on my right handed 08 Aigil .... Everything looks good so far as center shot.. POI may be a little off but not enough that I can tell at 25yds....My question is which side on the right handed aigil does the "thicker" spacer go on ? Holding the bow in the shooting position , I have the thicker spacer on the right side of the cam & idler wheel..
10-27-2009, 03:41 PM
Just for the sake of argument...aren't they the same size? I am only playing the devil's advocate here
10-27-2009, 08:04 PM
No,,,,,, they arent the same size , one is thicker than the other........Tech support got back with me shortly after I left a message....The "thicker" spacer goes on the string side .. I changed them over and see that I have a bit of day light showing through the spacer on the cam..I have a spacer kit on the way..The idler has just a small bit of light and just a hair of play but will soin freely and not sloppy..I was told that the idler should be fine.
10-27-2009, 10:03 PM
Mine on the bottom cam has 40 on the right and 60 on the left. Top cam has 40 on right and 50 on left. This could change depending on limb openings but looks like bigger shims are on left,hope this helps. This is looking at it as shooting the bow.
10-28-2009, 06:27 AM
10-30-2009, 12:40 PM
Ok got my cam taken care of .. My idler wheel still hass just a bit of light shining through . There is just SLIGHT slop to it but I was told that you wany your idler wheel to spin freely or you will run into verticle issues..Any suggestions ?
Powered by vBulletin® Version 4.1.10 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.