archer58inPA
01-23-2008, 10:10 PM
I spoke with Michael today a couple times on the phone. I recieved the Synergy I had been waiting for. ( I hope you're out there Michael)
It's a lefty model and it came set at 71# and 29'' draw.
I am 28" draw and wanted to start off with the bow set at 65#.
So , away I go. I first moved the mods to the proper position.
Next, I checked ATA ,BH and took 1 1/2 turns out of the limb bolts.
Then set the draw stop to 5.8. Also checked tiller.
O.K. , time to check the module stop position and Syncronization.
On the hanging scale it showed the need to twist the cable to retard the top cam a little. I did so. one twist, 1/2 twist , another 1/2 twist. UhOh !
Something's wrong. I was able to sync the cams pretty close( No draw board w/i 100 miles of here) to perfect, BUT , the mod stops hit the cables BEFORE the draw stop. Hhhmmm.
Call Micheal again, ( he's very patient) Says ,it's wrong. Yeah I know. Now what? I'm going to fiddle w/ it. "I'll Call you back."
Set the bow back to spec at 71/29. BTW, the BH was and is 7 1/4".
O.K. same procedure...this time moved draw stop to 6.0. and 1 twist in each cable. Now that's better.
The cable stops DO touch the cables , but don't push them.
Should I , (1) put another twist in the cables? (2) or move the draw stop to 6.1?
The draw stop and the mod stops move the same when cables are twisted / untwisted. They're on the same cam.I don't think that will help.
Moving the draw stop WILL keep the mod. stops off the cables.
I am at 80% letoff.
What do you think? Sorry I missed your last call Michael...kids had homework. I hope you're out there.
Geno
It's a lefty model and it came set at 71# and 29'' draw.
I am 28" draw and wanted to start off with the bow set at 65#.
So , away I go. I first moved the mods to the proper position.
Next, I checked ATA ,BH and took 1 1/2 turns out of the limb bolts.
Then set the draw stop to 5.8. Also checked tiller.
O.K. , time to check the module stop position and Syncronization.
On the hanging scale it showed the need to twist the cable to retard the top cam a little. I did so. one twist, 1/2 twist , another 1/2 twist. UhOh !
Something's wrong. I was able to sync the cams pretty close( No draw board w/i 100 miles of here) to perfect, BUT , the mod stops hit the cables BEFORE the draw stop. Hhhmmm.
Call Micheal again, ( he's very patient) Says ,it's wrong. Yeah I know. Now what? I'm going to fiddle w/ it. "I'll Call you back."
Set the bow back to spec at 71/29. BTW, the BH was and is 7 1/4".
O.K. same procedure...this time moved draw stop to 6.0. and 1 twist in each cable. Now that's better.
The cable stops DO touch the cables , but don't push them.
Should I , (1) put another twist in the cables? (2) or move the draw stop to 6.1?
The draw stop and the mod stops move the same when cables are twisted / untwisted. They're on the same cam.I don't think that will help.
Moving the draw stop WILL keep the mod. stops off the cables.
I am at 80% letoff.
What do you think? Sorry I missed your last call Michael...kids had homework. I hope you're out there.
Geno