E500 Draw Stop - Help

[eric866121]

I have an E500 that had the latest Cams (by Elite) put on this past summer. Ever since I've got it back the draw stop setting has been extremely sensitive (slight change - goes from no valley to huge valley) and I can't even go by the chart setting as a stating point.

What would cause this? Is this a tuning issue?

The local bow shop who supports Bowtech can't figure it out.

Specs on bow:

E500 Bow
30" Draw
E500 Mods

[Elite_Kevin]

First check the synchronization of your cams at full draw.

Second if they are in synch, move the draw stop .010 and recheck your valley, repeat this .010 movement of draw stop until you have the desired valley.