draw stops

[mex]

do you need a draw stop pin only on the top cam?I just picked up a synergy and went to ajust the stop but the brass looks striped so im also going to need a new brass nut for the draw stop.

[t8er]

You should only need one but some people use two. Once you find your setting I would suggest using some blue loctite to prevent it from loosening up on you. I had a Bowtech Allegiance that I drew back once and I heard a rattle on the top cam. I let down and found out that the stop was completely loose. Luckily it was an 06 with the stops built into the cams and I didn't draw hard enough to pull past them or I would have been in trouble.

[TEXAS 10PT]

do you need a draw stop pin only on the top cam?I just picked up a synergy and went to ajust the stop but the brass looks striped so im also going to need a new brass nut for the draw stop.

Call Elite. They have replaced the brass nuts with stainless steel ones to eliminate the stripped threads.

TEXAS

[mex]

Call Elite. They have replaced the brass nuts with stainless steel ones to eliminate the stripped threads.

TEXAS

Thanks,do you have the phone number??

[TEXAS 10PT]

509-529-0626

Texas