e-force letoff

[shootinfast]

I've asked this before on another forum but will ask on here now where should the draw stop peg be located on an e-force to get 80% or say close to 85 which is now legal here I see numbers 0on top and 12 on bottomI've tried playing with the positioning but only made it worse can any one help and remember I'm not as smart as I think I'am so pictures would help .

[t8er]

Depends on your draw length.

[shootinfast]

28.5 speed mods does that help?

[Scablands]

Start around 5.1 according to the spec. sheet that came with the bow.

[shootinfast]

this is a dumb question but where do I get that measurement from is it from 0 and what is the unit is it millimeters or ? sorry for these questions but I've really got no shop to turn to for answers so I use you guys for solutions.

[Scablands]

Start from the 0 and count lines... 1,2,3,4,5.

[shootinfast]

thanks alot I will go tinker in my Garage

[t8er]

The 5.1 setting will get you close but if you still aren't getting 80% you can adjust it in small increments from the 5.1 setting until you get there. Make sure you get the draw stop good and tight when you find your sweet spot....you don't want it to loosen up on you later.