Correct position for draw stop peg???

[YaleMan]

My Synergy cam module is set on the 3 position, but the draw stop peg is on the 5 position. Should they be the same? The cams are timed perfectly at this setting. But a little more let off would be nice.

[Just 1 More]

http://i64.photobucket.com/albums/h161/Just1moreII/2007Synergy.jpg

[Just 1 More]

My Synergy cam module is set on the 3 position, but the draw stop peg is on the 5 position. Should they be the same? The cams are timed perfectly at this setting. But a little more let off would be nice.

it's Exactly where it's supposed to be